Kendrion 01310 series permanent holding magnets have a rectangular shaped body made from hardened precision steel for maximum protection and performance.

The coil is fully potted with resin to prevent dust, oil, grease, liquids, vapour and mud ingress.

Permanent holding magnets consist of a permanent magnet to hold ferromagnetic workpieces. When energised, the permanent magnet neutralises, and the workpiece disengages.

As a result, these holding magnets are ideal where long holding periods are required and energised for short times only.

Permanent holding magnets are used as safety magnets in transportation devices as loads are held reliably even in a power failure situation.

There are two bar lengths to choose from; the largest achieves up to 1,530N of holding force.

The maximum holding force is dependent on the material’s surface, the material thickness, and an air gap of 0mm.

The standard voltage/duty cycle is 24V DC / 25%ED with a screw connection gland orientated to the bottom or side of the permanent holding magnet.

Part Numbers Show…

01 31007A00 | 01 31008A00 | 0131007A00 | 0131008A00